Page 1 of 1

Bug: Whitelist ignores WebGL filter option

Posted: Mon Jun 03, 2013 4:59 pm
by Jorgo
Hello,

I have activated all options under the "Embeddings" tab except to "Apply these restrictions to whitelisted sites too". I have a blog based on the TYPO3 CMS, which I have whitelisted in NoScript. When logging into my CMS backend, NoScript tells me it has blocked WebGL options which I can then temporarily enable. This should not be happening with the above combination of options, IMHO. I have tried whitelisting with short domain, full domain and qualified URL, all with the same result. Thanks for looking into it!

Best,
Jorgo

Re: Bug: Whitelist ignores WebGL filter option

Posted: Mon Jun 03, 2013 5:34 pm
by therube
I believe anything listed below "Apply these restrictions to whitelisted sites too" is going to act globally if enabled?

Re: Bug: Whitelist ignores WebGL filter option

Posted: Mon Jun 03, 2013 7:19 pm
by Giorgio Maone
therube wrote:I believe anything listed below "Apply these restrictions to whitelisted sites too" is going to act globally if enabled?
Correct.

Re: Bug: Whitelist ignores WebGL filter option

Posted: Mon Jun 03, 2013 10:40 pm
by Jorgo
I see. Maybe it could be made a bit clearer by grouping these options somehow visually.

Re: Bug: Whitelist ignores WebGL filter option

Posted: Mon Jun 03, 2013 10:52 pm
by Giorgio Maone
Jorgo wrote:I see. Maybe it could be made a bit clearer by grouping these options somehow visually.
Actually, to be more precise, "Forbid WebGL" is not listed above because it does make sense only if JavaScript is enabled. In facts, you can create a 3D (WebGL) canvas only through JavaScript, therefore this option is meaningful on whitelisted sites only.

Re: Bug: Whitelist ignores WebGL filter option

Posted: Mon Jun 10, 2013 3:18 am
by Thrawn
Is there a preference in about:config to specify exceptions for this?

Re: Bug: Whitelist ignores WebGL filter option

Posted: Mon Jun 10, 2013 11:53 am
by Giorgio Maone
Thrawn wrote:Is there a preference in about:config to specify exceptions for this?
Please check latest development build 2.6.6.6rc1, thanks.